Wilson Amplifiers: Cellular Repeater, Mobile Repeater, Cell Antenna Booster
This Wilson Mobile Wireless cellular signal booster system features the benefit of an external antenna and 3 watt amplifier without a physical connection to your phone. It even improves cellular signal multiple phones and/or cellular data card for faster mobile Internet speeds. The cell signal is received by the outside antenna from the cell site. It is then amplified and repeated to your cell phone or data card from the inside antenna.
Cars, Trucks, RVs, Home, Office
- Takes outside signal, amplifies it and rebroadcasts inside
- Reduce Dropped Calls
- Increase Service Area
- Works with Cell Phones and Cellular Data Cards
- Works with most US & Canada providers (AT&T, Alltel, Sprint, T-Mobile, Verizon, etc.)
Home or Office Too!
Add an optional 6 volt AC power supply and use this cell phone signal booster at your desk in your home or office. Just place the outside antenna outside a window and get at least 6 ft of separation between the 2 antennas. Need to cover more area in side your home or office?
Wilson Mobile Wireless DualBand Cellular Amplifier
- Requires No Physical Connection to Your Cell Phone
- Power Control Logic Ensures Maximum Output Power is within Cellular Standards
- Allows Multiple Phones and/or Cellular Data Cards to be Used Simultaneously
- Maximum 3 Watts Output Power (cell site controlled)
- Designed for Most 800MHz & 1900MHz Systems Including AT&T, Sprint, T-Mobile, Verizon, Rogers
- LED- Power & Overload Shutdown/Oscillation
- Overload Protection Circuit - Protects Cell System from Overload
- Automatic Reset - If overload occurs
- FCC Type Accepted
The Amplifier That Out Performs Other Units
Tests show Wilson Cellular's Dual Band Wireless Mobile Amplifier outperforms Digital Antenna® and RF Engineered Solutions® (RES).
Additional Antenna Requirements (Important)
The Wilson Mobile Wireless Amplifier comes with a Wilson Low Profile Antenna for inside your vehicle. Another antenna for outside the vehicle is required.
Required Antenna Separation
Separation of inside and outside antennas is very important. The metal roof of the vehicle acts as a barrier and helps shield the two antennas from each other, preventing oscillation. If the vehicle has a sunroof, it is important to separate the inside and outside antennas by at least five feet. This prevents the amplifier from overloading or oscillating.
Outside Antenna Requirements
For external antenna use a magnetic mount, pole mount or hole mount antenna. Do not use a glass mount antenna. The Wilson Trucker Antenna, Wilson Dual Band magnetic mount are recommended for outside use. More About Wilson Antennas.
Wilson Mobile Repeater Specifications
- Frequency 824-894 MHz / 1850-1990 MHz
- Gain 40db / 45db
- Max RF Up/Down +35 dBm / +10 dBm
- Noise Figure Typical 3 dB nominal Isolation
- Uplink/Downlink more than 90 dB
- Power Requirements 12 V, .5-1.5 (subject to Uplink power)
- Connectors FME-Male 50 Ohms
- Dimensions 4.5 x 3.5 x 1.25 (inch) or 11.43 x 8.9 x 3.2 (cm)
- Weight 1.5 lbs or 0.7 kg
