Wilson 800MHz Cellular Repeater Kit
Wilson's In-Building 800MHz Amplifier system offers exceptional performance without causing harmful interference to the cell site. Wilson's bi-directional amplifiers are the most technologically advanced cellular amplifiers on the market today. Their most important feature is patented oscillation shutdown protection, which activates complete shutdown within just a few milliseconds to prevent harmful interference to cell sites. Wilson amplifiers also offer completely adjustable software-controlled automatic gain control, both on forward and reverse links, which allows the amplifiers to meet CDMA and GSM ACPR requirements. The amplifiers are invisible within CDMA and GSM systems. They also have the capability of following base station power requests which allows maintaining the full power dynamic range of the cell phone.
Repeater Kit includes
- Wilson 800MHz 50db Building Amplifier (801105)
- 10dbi 800MHz YAGI Antenna (301129)
- Wilson Wall Mount Panel Antenna (301135)
- One 20 foot Wilson-400 Cable (952320)
- One 50 foot Wilson 400 Cable (952350).
Also See:
-
About Cellular Repeaters
An in-building cellular repeater has 3 major components. An outside antenna, cellular amplifier and an inside antenna. The signal is received by the outside antenna from the cell site. It is then amplified and repeated to your cell phone through the inside antenna. When the phone transmits, the signal is received by the inside antenna, amplified, then repeated to the cell site via the outside antenna.
Features
- Wireless operation. No physical connection to your phone is required.
- Automatic Gain Adjusting in the event of oscillation and /or overload
- Automatic shutdown on overload
- TIA/EIA-98-E 3.5.1 Receiver Sensitivity better than -110 dBm
- CDMA/rho > .912
- Allows multiple phones to be use simultaneously.
- Your phone will use less battery power for longer battery life.
Antenna Separation Requirements (Important)
Requires at least 50 feet (40 feet if roof is constructed of metal or heavy concrete) of seperation between the inside and outside antenna. Do not turn on your amplifier unless you have at least the above distances between the inside and outside antenna. These distances must be maintained or the signal will just oscillate between the two antennas and no improvement will be noticed. Also, not enough separation can damage the amplifier.
IMPORTANT NOTE: In order for any repeater to be effective, you must have at least 2-3 bars of signal on the outside of the building. If there is little or no signal outside, the amplifier repeater will not radiate enough signal inside.
Specifications
- Frequency 824-849 MHz Uplink, 869-894 MHz Downlink
- Gain 50 dB max
- Max Output Power: Up to 3 watts
- Max RF + 25 dBm uplink / +25 dBm downlink
- Noise Figure 3 dB nominal
- Flatness ± 2.5 dB
- Isolation > 90 dB
- Power Requirements 120 V AC / 3 A max
- Connectors N-Female
- Dimensions 5.6 x 3.6 x 1.7
- Weight 1.5 lbs or 0.7 kg
